MBUK Build Guides
Search
⌃K

Helidox (Corne) High Profile Acrylic Case Guide (Wave Case)

NOTE: This guide is for one half of the case. Just mirror the steps for the other half
👍
​

All Contents

Piece
Amount
Image
Base
2
​
​
Middle
6
​
​
Plate
2
​
​
Top
4
​
​
Middle Side Piece (Bigger Holes)
6
​
​
Top Side Piece (Smaller Holes)
4
​
​
Thin Side Piece
2
​
​
OLED Cover
2
​
​
6mm Screws
30
​
​
8mm Standoffs
15
​
​
14mm Screws
8
​
​
10mm Screws
6
​
​
Rubber Feet
10
​
​
​

Build Steps (High Profile)

1 - Remove all protective film. Be careful not to scratch the acrylic pieces. Check all pieces are included. Let us know if anything is missing.
2 - Place a 6mm Screw through the Base Piece, protruding up
3 - Screw a 8mm Standoff onto the protruding screw
4 - Repeat steps 1 & 2 for all remaining holes on the base plate. Screw these tight
5 - Place 3 x Middle Piece onto the protruding standoffs
6 - Place 3 x Side Piece onto the remaining protruding standoffs
7 - Place the switch plate on top of the case so far. The plate should already have your switches and PCB installed. Make sure to REMOVE your existing OLED Cover.
8 - Add the tops layers, and screw everything together using the 14mm screws
9 - Separately, Add 2 x 14mm screws through the OLED Cover, through the top side piece, and through the thin side piece
9 - Screw this into place near the controller. Add feet to the bottom of the case. Your case is now complete!

Build Guide (Low Profile)

Follow all steps above until step 7. Place the extra 6mm screws through the plate and the thin side piece and use your standard Helidox OLED Cover.